Skip to content
SubmittalForge

CSI 03 20 00 — Concrete Reinforcing

ASTM A615 Grade 60 mill test report checklist

Standard Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement

Chemistry (% by weight)

Phosphorus (P)
≤ 0.06%

Tensile requirements

Yield strength
≥ 60 ksi
Tensile strength
≥ 90 ksi
Elongation in 8 in.
≥ 9%

Build America, Buy America

2 CFR 184.3

On federally funded infrastructure, ASTM A615 Grade 60 material is an iron or steel product: every process from initial melting through coating must happen in the United States. The mill test report should show a U.S. melt and pour location for each heat.

Edition, notes and sources

Checked against A615/A615M-26
  • A615 limits phosphorus only; carbon, manganese and sulfur are reported but not limited.
  • Elongation in 8 in. depends on bar size: #3–#6 9%, #7–#8 8%, #9–#18 7%. The checker reads the bar size from the product description when it can and otherwise applies 9%.

Sources

ASTM standards are copyrighted. These limits were cross-checked against published summaries; confirm them against a licensed copy of the edition your specification cites.

Reviewing an ASTM A615 Grade 60 mill test report

  • Confirm the MTR names ASTM A615 Grade 60 (or a dual certification that includes it).
  • Match the heat number on the MTR to the heat stamped on each delivered piece.
  • Compare the heat analysis with the chemistry limits above.
  • Compare the tensile results with the yield, tensile and elongation minimums.
  • On BABA work, confirm the country of melt and pour is the United States.