CSI 05 12 00 — Structural Steel Framing
ASTM A992 mill test report checklist
Standard Specification for Structural Steel Shapes
Chemistry (% by weight)
- Carbon (C)
- ≤ 0.23%
- Manganese (Mn)
- 0.5 – 1.6%
- Phosphorus (P)
- ≤ 0.035%
- Sulfur (S)
- ≤ 0.045%
- Silicon (Si)
- ≤ 0.4%
- Copper (Cu)
- ≤ 0.6%
- Nickel (Ni)
- ≤ 0.45%
- Chromium (Cr)
- ≤ 0.35%
- Molybdenum (Mo)
- ≤ 0.15%
- Vanadium (V)
- ≤ 0.15%
- Carbon equivalent (IIW)
- ≤ 0.45
Tensile requirements
- Yield strength
- 50 – 65 ksi
- Tensile strength
- ≥ 65 ksi
- Yield / tensile ratio
- ≤ 0.85
- Elongation in 2 in.
- ≥ 21%
- Elongation in 8 in.
- ≥ 18%
Build America, Buy America
2 CFR 184.3On federally funded infrastructure, ASTM A992 material is an iron or steel product: every process from initial melting through coating must happen in the United States. The mill test report should show a U.S. melt and pour location for each heat.
Edition, notes and sources
Checked against A992/A992M-22- Carbon equivalent limit is 0.47 for shapes with flange thickness over 2 in.; 0.45 otherwise.
- Manganese minimum may be 0.30% for shapes with flange or leg thickness ≤ 1 in. when Mn:S ≥ 20:1.
- Columbium (Nb) ≤ 0.05% and V + Nb ≤ 0.15% are also limited; not checked here.
Sources
ASTM standards are copyrighted. These limits were cross-checked against published summaries; confirm them against a licensed copy of the edition your specification cites.
Reviewing an ASTM A992 mill test report
- Confirm the MTR names ASTM A992 (or a dual certification that includes it).
- Match the heat number on the MTR to the heat stamped on each delivered piece.
- Compare the heat analysis with the chemistry limits above.
- Compare the tensile results with the yield, tensile and elongation minimums.
- Check carbon equivalent against the 0.45 maximum if the steel will be welded.
- On BABA work, confirm the country of melt and pour is the United States.