Subcontractor Pro, GC & Engineer, or a project with a project pass
Packet scanning reads the mill test reports, bill of lading and BABA letter from a PDF or image. Two separate passes read the file independently. Wherever they disagree, you choose the right value before anything is saved.
Scan
- Click Add submittal and choose the file under Packet PDF; or drop files on a submittal that has no documents yet; or open a submittal's Documents and use Scan PDFs or photos → Choose files.PDF or image files, up to 150 pages each. Several files are read one after another. A file already kept under Source files can be read with Read into submittal.
- Wait while it reads. The window shows how many pages have been read.Long PDFs are read 8 pages at a time, several batches at once. A 25-page packet takes about a minute; 150 pages can take several minutes. Keep the window open.
- The Review scan window opens with counts of mill test reports, bill of lading lines and whether a BABA letter was found.
Confirm the values
- Heats with values to confirm show Confirm and a count instead of a result, and those values are highlighted. For each one, check the page and click the reading that matches the document.Show next in the footer jumps to the next one. Heats where both passes agree say so. Only one pass found this heat means look at it closely.
- The page a heat was read from is shown beside the values.Click View page on any heat to see its page, and use the arrows to move through the file. The page comes from the file in your browser.
- Small differences don't count as disagreements.Case, spaces and punctuation are ignored ("U.S.A" and "USA" match), and a value neither pass found is simply not reported.
- A cert that appears more than once in the packet (for example under two bills of lading) is listed once, with every page it's on.
- If any pages couldn't be read, they're listed at the top. Add those certs afterwards in Documents (enter them by hand, or scan just those pages).
- If the second pass found heats the first didn't, they're listed at the top. If they belong to the packet, add them afterwards with Documents → Enter a mill test report by hand.
- If both readings of a value are wrong, pick either, then correct it with the pencil on that heat in Documents.
- A cert that reports two or more tensile tests for a heat has every test checked.The lowest-yield test shows as the heat's yield, tensile and elongation; the others appear as Tensile test 2, 3 and so on under MTR values. If the two readings differ on those, Other tensile tests is one of the values to confirm.
- Under each heat, Show the values read and the checks lists every value read, what the grade requires and whether it passes. A heat that fails starts open, with the failed checks highlighted. Compare the values with the page on the right.
- Use these values stays unavailable until every highlighted value is confirmed. When the footer says Nothing left to confirm, click it to add the reports to the submittal; failed checks stay flagged there. Click Discard to throw the scan away.
- If you scanned from the Documents dialog, review the values and click Save.Save waits until the scan finishes. Scanning the same file again updates the heats already there instead of adding a second copy.
- The values you confirm are saved with the submittal, and the file itself is kept under Source files so anyone on the project can open it and it goes into the stamped PDF. See Attach documents.
- Grade not supported means the mill cert is for a grade SubmittalForge doesn't check yet. Its values are kept but not checked against limits.
- Each organization can run up to 300 document reads (packet scans plus spec sections) a day, resetting at midnight UTC. Each batch of 8 pages counts as one read, so a 150-page packet uses about 22. See Usage limits.
Still stuck? Email support@submittalforge.com with your organization name and what you were trying to do.